Rick's b.log - entry 2009/07/03

Problems galore, but nothing insurmountable!

There was a further small delay as Ewen, well beyond the call of duty, fired up his SCP client and went and deleted all of the HTML files... by hand, one by one. There's loads of subdirectories and loads of files. We're probably looking at over a thousand.

Then, an interim update was put in place with the 'essentials' put back in place. Google gave the site a checking over and reported it was okay.

Whoo-hoo, this crap is finally sorted. Now to work on getting back to normal, and then to stuff (such as Eurovision) that were deferred...

Anyway, loads of kudos to Ewen for his work getting HeyRick sorted.

A new look

If you want to reminisce on the original layout that HeyRick offered for over a decade, it's there on the right - and you can click the picture for a full-sized version.
The old version had logos on some of the buttons. I plan to introduce these to the new version as well, I just didn't have time today.

Let me know what you think, and don't forget that there's also a text-only version available.

Extra cooling

So I opened up the machine. A variable-speed fan was mounted on the outside of the PSU to blow air through it. The little controller board was attached to one of the two heatsinks. The power for the circuit was taken from the 12V supply to the original fan. Accordingly, the fan has cranked up to maximum temperature in about a minute, the PSU still runs hot, but now there's twice the air flowing through. This should also, hopefully, assist with sucking air out of the box to keep the insides replenished with cold air (as the GPU and CPU fans don't point to anything in specific, so long as heat is taken away from the respective heatsinks).
In order to aid air circulation in the lower part, and lower the temperature of the harddiscs, another fan was installed to suck air in through the lower expansion slots. This fan runs off 5V and is powered by tapping in to the additional supply to the graphics card.

The picture below is at a strange angle. Upper right is the PSU with the extra fan bolted to the outside. This is at the top of the box. Upper left is the fan tapped off the graphics card. This is the the bottom of the box. To the front (lower middle of the picture) you can see the harddiscs, one being 250Gb and one being 80Gb (those are decimal gigabytes). They are unplugged in this picture as I was testing to check the fans were going to work as desired.

The downside? A computer with two harddiscs and four fans is, well, a tad on the noisy side!
Still, at least I restrained my psycho tendencies. It had crossed my mind to take the blanking slots off the two unused 5¼ bays on the front and bolt on that old three-phase extractor fan I have kicking around someplace. The power cable is as thick as your thumb, hooked to a plug the size of a plastic beaker. Why didn't I? It sounds like a jet engine warming up. There's a limit to sanity, and a three-phase ass-kicking fan is beyond that limit!

Your comments:

Please note that while I check this page every so often, I am not able to control what users write; therefore I disclaim all liability for unpleasant and/or infringing and/or defamatory material. Undesired content will be removed as soon as it is noticed. By leaving a comment, you agree not to post material that is illegal or in bad taste, and you should be aware that the time and your IP address are both recorded, should it be necessary to find out who you are. Oh, and don't bother trying to inline HTML. I'm not that stupid! ☺ ADDING COMMENTS DOES NOT WORK IF READING TRANSLATED VERSIONS.
 
You can now follow comment additions with the comment RSS feed. This is distinct from the b.log RSS feed, so you can subscribe to one or both as you wish.

Rob, 24th October 2020, 16:17

rm -rfv *.html would expand to a list of *.html files /in the current directory/, delete them, and look recursively down if any of those had actually been directories. Remember, * etc is expanded by the *nix shells before they even get passed to the command, unless you escape the * with a \    You really need something like  find . -name \*.html -exec rm -rf {} \;    which finds all files so named, and then executes a remove on them.    Sorry this is a little late, but you did ask for an explanation, and didn't give a timeframe... :-)

Rob, 24th October 2020, 16:59

And then I read ahead and find a much longer explanation you posted a few days later. Feel free to delete these comments...

Add a comment (v0.11) [help?] . . . try the comment feed!
		Your name
		Your email	(optional)
		Validation	Are you real? Please type 80395 backwards.
		Your comment